LIST OF HARDWARE AND SOFTWARE REQUIREMENTS
Make an Arduino Robot
This page contains lists of required parts and tools for the course "Make and Arduino Robot".
The following lists contain the parts and tools necessary to complete the construction of the robot, as shown in the project course Make and Arduino Robot.
Many of the items below are reusable. Items like soldering irons, precision screwdrivers, Arduinos etc will last for many years if you look after them. Other items like resistors, spacers and potentiometers come in packs that contain sufficient numbers to last for many projects.
The items in these lists are provided in an effort to make it easier for our students to find the parts and tools they need. While we take care to find reliable Amazon sellers, we cannot be responsible for problems in their supply chain or fulfilment. Sellers may run out of stock at any time, or shipments may be lost in transit. For issues like these, or for warranty claims, please contact the seller or Amazon directly.
If you do not live in the US, UK or Germany, or the Amazon stores that we provide links to below do not deliver to your location, consider using a freight forwarding service like Shipito. You can ship your shopping to them, and they will forward to you, anywhere in the world. This is useful in case, for at least some of the items in your shopping list, Amazon will not ship to addresses outside the US.
Found a problem in this list?
If you find errors in this parts list, please help us fix it by raising a support ticket.
Arduino Uno (Genuine)
Arduino Uno (Sunfoudner Clone)
Amazon US | Amazon UK | Amazon DE |
2 x Continuous rotation servos (SpringRC SM-S4303R)
2-5/8" Plastic Yellow Wheel Futaba Servo Hub
9g SG-90 Mini Servo
Ultrasonic Sensor (HC-SR04)
Servo mounting bracket for HC-SR04
Lynxmotion E-Z Aluminum Servo Bracket (Two Pack ASB-02)
25mm X 3mm Tapped Metal Spacers with matching screws
2 x Light Dependent Resistor (LDR)
2 x 10 kΩ resistors AND 2 x 330 Ω resistors
2 x Light Emitting Diodes (LED)
10 kΩ potentiometer
2 x electrolytic capacitors with capacity between 100µF to 470µF
Arduino Uno compatible prototyping board shield
2 x 4xAA battery holders
9V Battery Clip
Bluetooth Module (HC-06)
Breadboard-friendly SPDT Slide Switch
2 x Screw Terminals 2.54mm Pitch (2-Pin)
Screw Terminals 3.5mm Pitch (3-Pin)
Precision anti-static tweezers
Electrical insulation tape
Soldering iron and solder (check mains power requirements for your location)
PCB holder (to make soldering easier)
Solder pump (to help in fixing soldering errors)
Thin single core wire